U-Reach MT-U Series SATA HDD duplicator is capable of copying at 30GB/min. on all targets simultaneously, without any speed degradation as number of targets increase. This duplicator is great for manufacturers.

Illustration of Copy Modes 

The areas containing data are marked in blue. The areas being copied are marked in red. Duplication time depends on the speed supported by the hard drive's controller chip.

●Quick Erase:
  Erase HDD index table, and only takes A FEW SECONDS to complete.
●Full Erase:
  Erases the entire HDD.
●DoD Erase:
  Complies with U.S. Department of Defense erasure standards. 
●Secure erase:
  A National Institute of Standards and Technology 800-88 accepted
  technique for properly purging hard drives. This method is supported by almost all modern SATA/SAS HDD.

MT-U Series HDD/SSD duplicator enable end-users to set the minimum writing speed threshold. This feature was developed to prevent and to eliminate problematic devices that halts the duplication and sanitizing process.

U-Reach duplicators makes straightforward copies, but it is imperative that the copied data are verified through a bit-by-bit process, this will ensure successful copied and reduce customer recalls.

End-users are given options to skip bad sectors from the source device. Access the function to select the numbers of bad sectors to skip, from 0 through unlimited.

U-Reach HDD/SSD duplicators has an unique mechanism to prevent alteration of its Event Log Report. It records the operation results and other information of each devices completely. It is an important asset for production management and analysis.